Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tremron Kitchen Remodeling: The Tampa Owner’s Guide
If you have a Tremron paver or outdoor kitchen component that has failed and are looking at a kitchen remodeling project in Tampa, a full kitchen remodel typically runs $14,000 to $45,000 in this market depending on cabinet grade, countertop material, and the condition of the walls behind the old finishes. We stock and install Tremron-compatible masonry materials and can tie an outdoor kitchen or paver surface into a larger kitchen remodel, and we give every Tampa homeowner a written price before any work starts. Most people call us after they notice one specific thing: a Tremron paver has shifted or cracked near a kitchen wall, or the outdoor kitchen’s base has settled enough that the countertop no longer sits flush.
What surprises most Tampa families is how often a failed Tremron surface is not a Tremron problem at all. It is a base problem. Florida’s sandy soil, our wet season, and a poorly compacted sub-base will move a paver long before the paver itself fails. Graham Stein has pulled apart enough of these installations in Seminole Heights and Westchase to know that the paver is usually the symptom, and the base prep is the disease.
Which Tremron Models This Applies To
Tremron manufactures concrete pavers, wall blocks, and outdoor kitchen components in a range of series, and the compatibility question matters more than most Tampa homeowners expect. The most common Tremron lines we encounter around Tampa are the Mega Olde Towne, Mega Arbel, Mega Bavarian, and the Tremron wall block series used for outdoor kitchen bases. Each series has a specific dimensional footprint, and a paver from one series will not cleanly replace a paver from another without a visible seam or a height mismatch.
When we match a replacement, we do not guess. We pull one intact paver, measure the actual length, width, and height in millimeters, and check the underside for the mold code. Tremron stamp codes vary by plant run, and older Tampa installations from the mid-2000s used molds that are no longer in production. In those cases, we source a color-matched aftermarket paver that matches the height within 1/16 inch. The honest truth about Tremron OEM versus aftermarket: for color-drift reasons, a full paver replacement in an outdoor kitchen area often looks better with a new matching set than with a single OEM piece that has faded differently from the surrounding pavers.
If the failed part is actually the wall block behind an outdoor kitchen counter, the same rule applies. We pull the block, check the series, and match what still exists. We also carry Tremron-compatible edge restraint, bedding sand, and paver joint sand on the truck for every outdoor kitchen job. Elmstead Remodeling Tampa is an independent service provider and not affiliated with Tremron, but we work with their product lines regularly enough to know their tolerances.
Styles & brands we work with
Signs Your Tremron Kitchen Remodeling Is Failing
- The countertop no longer sits flat. If your outdoor kitchen counter rocks or shows a visible gap at one end, the base below has shifted. In most Tampa installations, this is a sub-base compaction issue, not a broken paver. We check the entire base before we touch the counter.
- Pavers have drifted apart at the corners. When edge restraint is missing or installed too shallow, Tampa’s heat and the natural expansion of concrete will push pavers outward. You will see spreading at the outside corners first, which is the classic sign the edge restraint was never installed correctly.
- A single paver has sunk. One sunken paver is almost always a soft spot in the base below, often from a poorly compacted patch or a hidden irrigation leak. Florida’s sandy soil does not hold an uncompacted base. We excavate that spot, repair the base, and re-set the paver at the right height.
- Joint sand is disappearing after heavy rain. Tampa’s summer storms will wash joint sand out of a Tremron surface if the paver joints were not properly filled or if polymeric sand was used without the proper moisture. This shows up as loose pavers and a surface that sounds hollow when you tap it.
- The face of a wall block is chipping or flaking. Concrete wall block absorbs water, and Tampa’s wet season followed by hot dry spells is rough on block faces. Surface flaking on a Tremron block usually means water got behind the face during a cold snap, which is rare here, or the block was hit hard enough to crack the face. Either way, the structural condition of the block matters more than the cosmetic chip.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A full kitchen remodel in Tampa runs $14,000 to $45,000 by our pricing, with cabinet grade, countertop selection, and wall condition driving most of the range. If the Tremron component is limited to an outdoor kitchen base, a masonry repair component is smaller. For the broader kitchen remodel, here is how our Tampa pricing breaks down across the common line items:
| Scope | Typical Tampa Installed Range |
|---|---|
| Full Kitchen Remodel | $14,000 – $45,000 |
| Small Kitchen Remodel | $9,000 – $20,000 |
| Cabinet Installation | $4,000 – $13,000 |
| Countertop Installation | $2,000 – $6,500 |
| Backsplash Installation | $800 – $2,500 |
| Kitchen Island Installation | $3,000 – $10,000 |
Every quote we write is fixed-price. We write it down before we start, so nobody is guessing mid-project. That written price includes the drop cloths, the shoe covers, the clean-up photo before the crew leaves, and the quiet-hours scheduling we agree to at the start. If it is not done right after we finish, we make it right under our 365-Day Done Right Promise.
DIY or Call Us?
There are two things a Tampa homeowner can safely check before calling anyone. First, look at the edge restraint around the paver area. If you can see bare soil at the outside edge or if the restraint has pulled away from the pavers, that is a problem you can identify. Second, look for standing water or a soft spot. Neither check requires tools, and both tell you something real.
What we do not recommend is pulling up pavers yourself and re-setting them over the same base. The base is the part that fails first in most Tampa installations, and re-setting a paver on a soft base just moves the problem forward a few months. If the countertop is involved at all, or the wall block has shifted, you are dealing with weight and geometry that needs to be right the first time. Call Graham Stein and the crew at (850) 779-4017 and we will look at the base, the restraint, and the surface together before we quote anything.
FAQs
A properly installed Tremron surface in Tampa lasts 20 to 30 years before the base typically needs attention, though color fading happens sooner, especially with darker pavers in full sun. The paver itself holds up; the base and the edge restraint are what fail first if the original install cut corners. Call (850) 779-4017 and we will inspect yours and tell you exactly what is left in it.
A chipped face on a Tremron paver can sometimes be patched with a color-matched concrete repair product, but for a paver in a kitchen area, we rarely recommend it. Tampa’s heat and moisture will make the patch show within a year, and a replaced paver looks better and costs less in the long run. Call (850) 779-4017 for an exact quote after we see the damage.
Most repairs take one to two days on site. If the base needs to be re-compacted, we add a day for excavation and re-installation. We schedule the work around your family’s quiet hours and confirm the written price before the first cut. Call (850) 779-4017 to schedule a free estimate and a firm timeline.
We keep Tremron-compatible edge restraint, bedding sand, and joint sand on the truck for every outdoor kitchen job, and we source matching pavers and wall block from local Tampa suppliers once we have measured your existing surface. We also stock kitchen remodeling component brands including KraftMaid cabinets, Cambria and Silestone countertops, and the fixtures that get specified into the walls. Call (850) 779-4017 and ask what is on hand.
Written by Graham Stein, Owner, Elmstead Remodeling Tampa at Elmstead Remodeling Tampa, serving Tampa and nearby areas.
